Re: Fire (pine knots)



Mario Petrinovich wrote:

Pine knots are full of resin. It wouldn't be hard tu imagine a
monkey breaking off a branch of pine, exposing resin to the sun. If that
monkey was in water, the sun can magnify through water drops, and ignite
resin. -- Mario

"in water"?

Let me see if I visualize this as you do:

Sun -> water -> branch with resin

So, the branch is under water? And it's supposed to ignite?
.



Relevant Pages

  • Fire (pine knots)
    ... Pine knots are full of resin. ... monkey breaking off a branch of pine, exposing resin to the sun. ...
    (sci.anthropology.paleo)
  • Re: soo-soft water softener??? Does it work???
    ... There are resin inside the softer that will "filter" out the minerals ... I am currently using Ecowater with potassium: http://www.ecowater.com ... softener salt or salt substitute. ... Water softeners work by replacing ...
    (alt.home.repair)
  • Re: water softening question
    ... > I have a dilemna concerning water hardness testing. ... > It is unlikely that the softening cartridge could have been changed ... > magnesium, quality of the resin, and an effect called "dumping". ...
    (sci.chem)
  • Re: Pipe down, you...
    ... NOT strong at elevated temperatures and I would be inclined to do the repair in polyester resin *IF* I could get the muffler clean enough. ... I'd lay up the first few layers resin rich with as much glass microbubble additive as I could use to attempt to provide thermal insulation for the outer layers then switch to normal laminating, keeping the resin ratio as low as possible without compromising the layup. ... The clean-up after an exhaust failure is also not fun and you can take on surprising amount of water via a failed exhause. ...
    (rec.boats.cruising)
  • Re: lining water tanks
    ... I have woven cloth, polyester resin, gel coat and a waxing agent that when mixed to the gel coat allows it to air dry. ... I had thought of using epoxy resin, which I understand is more water resistant, but when I went to buy some, it was suggested that epoxy might leach nasty things into the water..... ... Potable water approved epoxies are common in water treatment facilities. ... Most, if not all, NSF 61 approvals are only for tanks greater than 1000 gallons. ...
    (rec.boats.building)

Loading