Re: Why only crap in this NG? (was Wolter claims ...)



Philip Deitiker wrote:
> "hyperoglyphe" <hyperoglyphe@xxxxxxxxxxxxxxx> says in
> news:429c0482$0$5105$5a62ac22@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx:
>
> > It must be about time to slide back into the VM groove.
>
> Ken is still here, we haven't left.
>
> You know what we haven't seen in a long time is a fat out discussion
> about the Newport Tower. Let us not forget mooring holes on SE US
> rivers. And what about the viking garmetry found in canada.
>
> http://groups.yahoo.com/group/sciarchauxilliary/files/Controversies/
> Beardmore.rtf
>
> http://f5.grp.yahoofs.com/v1/YP2bQink-Eycd29GOxWBWaPCJxUu4-
> dIyfEtMm1bjGuUvruLfTU5X-
> 3APyxOPuUrCYd3IXdEWPkYmQSfjlFVglppuf72O2tA/Controversies/NewPortTower
> .rtf
>
> Yeah, I mean Viva Norumbergeria! Who wants to count corpses in
> Greenland.

She's still got the 'inland seacoast' and 'trees in a treelessland' up
her copious sleeve

.

Relevant Pages

  • How to shellac/poly the inside 5 sides of drawers (with a sliding bottom)
    ... I've got a never used Purdy 3" natural brush and could use shellac, ... got to finish the inside 5 sides of eight drawers. ... then slide it in finished? ... in the groove. ...
    (rec.woodworking)
  • Re: 1 VFD--2 Motors can it be done?
    ... each groove, then set and lock your compound and slide, and the apron ... "I think this is because of your belief in biological Marxism. ...
    (rec.crafts.metalworking)
  • Re: 1 VFD--2 Motors can it be done?
    ... then use a cut off tool to slit down the exact center of ... each groove, then set and lock your compound and slide, and the apron ...
    (rec.crafts.metalworking)
  • Re: Drawer Slides?
    ... what's the chance you could dado or grooove the drawer ... >sides themselves to create a groove for the side slide to go into, ...
    (rec.outdoors.rv-travel)