Re: OScope on PC Serial Port

From: Bob Masta (NoSpam_at_daqarta.com)
Date: 07/18/04


Date: Sun, 18 Jul 2004 14:36:58 GMT

On 18 Jul 2004 06:17:47 -0700, spm_sux@msn.com (Bill) wrote:

>I recently built an oscilloscope project that connects to a PC via a
>serial port:
>
>http://scopeonpc.tripod.com/
>
>It uses an ADC0820 ACD converter and a multiplexor and was real easy
>to put together. The owner of the web page has a demo version of
>software freely available that is limited to fixed time and voltage
>display scales.
>
>I have offered to pay the software author the registration fee for
>program to "unlock" the demo version and allow use of the voltage and
>time scaling functions but have not made much headway. Has anyone run
>across this project before or knows of a similar software program that
>would be able to read data from this project? Thanks in advance for
>any information the group is able to provide.
>
>Bill

Actually, this project uses a *parallel* port, not a serial
port.

I have no info on this project. However, if you just want
an inexpensive PC scope, you might want to check out
my Daqarta software with the LPTX driver. The ADC
"board" can be as simple as a handful of resistors wired
into a connector shell. (Some ports with uneven bit drive
levels may need a '373 buffer.) The resistors are just
an 8-bit R-2R ladder DAC, and the PC is doing all the work
to drive it as a successive approximation ADC. So the
top sample rate is usually around 40 kHz.

With the Daqarta software you not only have complete access to
sensitivity and time-base, you also have a built-in spectrum
analyzer, spectrograms, histograms, signal averaging, etc.
And you can use the same LPTX gadget in DAC mode with
Daqarta to generate a huge variety of signals. (This simple
circuit won't acquire and generate at the same time, however.)

Hope this helps!

Bob Masta
dqatechATdaqartaDOTcom
 
            D A Q A R T A
Data AcQuisition And Real-Time Analysis
           www.daqarta.com



Relevant Pages

  • Re: roZetta Status
    ... roZetta firmware is written in ZBasic and uses the ZX-40 from Elba, ... There is one main highspeed RS232 level serial port which interfaces ... with the TW523 as the ZX-40's interrupts are sluggish about 3% of the time. ...
    (comp.home.automation)
  • Re: How to Disable Ethernet
    ... you can use the serial port as an alternative method of getting debug. ... can disable KITL debugging and just read all of the messages that come out. ...
    (microsoft.public.windowsce.platbuilder)
  • Re: how to access the serial port exported functions in my applica
    ... you cannot access a serial port by loading the serial ... driver DLL into your application via LoadLibrary. ... I am trying to load com16550.dll using ...
    (microsoft.public.windowsce.platbuilder)
  • Re: Nokia LD-3W Bluetooth GPS/Samsung NC-10 netbook
    ... The little netbook is fully Bluetooth enabled. ... Tonight I got curious as to how the Nokia LD-3W bluetooth GPS would ... It created COM9 and used Bluetooth Serial Port protocol, ...
    (rec.boats.cruising)