Re: Strange Mosfet Results

From: Peter (pmolsen_at_one.net.au)
Date: 08/04/04 

Date: 4 Aug 2004 04:51:01 -0700

> Anyway this whole idea of a cap between gate and source doesn't seem
> to be helping.

...I mean between gate and drain.

Relevant Pages

  • Re: TIP50 for HT regulator
    ... gate zener protection and relatively inexpensive. ... cap multiplier is not a reservoir) and screen regulators. ... I still like to add external protection around all SS regulators, ... and the load, or cap to where the load is connected. ...
    (rec.audio.tubes)
  • Re: Capacitor Discharging with CMOS Gate
    ... (Charging circuit not shown for clarity) ... The cap dumps through the gate and blips the Vss rail. ... Since they come in the same package as ...
    (sci.electronics.design)
  • Re: Capacitor Discharging with CMOS Gate
    ... (Charging circuit not shown for clarity) ... The cap dumps through the gate and blips the Vss rail. ... Since they come in the same package as single diodes if you chose SOT23 or SC75 nobody would notice since there is no extra package :-) ...
    (sci.electronics.design)
  • Re: Capacitor Discharging with CMOS Gate
    ... (Charging circuit not shown for clarity) ... The cap dumps through the gate and blips the Vss rail. ... was much better hardened against scr latchup, ...
    (sci.electronics.design)
  • Re: Need higher speed 2N7002
    ... Most of the 10X driving solutions, (cascode, parallel gate inductor, ... couple-ns switching speed at 60 volts drain swing. ... For less than 5nS rise times you need <100R drain pull up ...
    (sci.electronics.design)