Re: ESD level measurement
From: amnon (amnon_pom_at_bezeqint.net)
Date: 08/13/04
- Next message: Pooh Bear: "Re: ESD level measurement"
- Previous message: andy: "Re: mosfet failure"
- In reply to: Dummy: "ESD level measurement"
- Next in thread: Pooh Bear: "Re: ESD level measurement"
- Messages sorted by: [ date ] [ thread ]
Date: Fri, 13 Aug 2004 22:04:14 +0200
Hi
I think the scope would be protected against ESD and that 250V are for
constant voltage and not a nSec spike.
A scope with 1Ghz BW will allow you to capture a nSec spike.
Use "Normal" mode at signal Negedge with threshold set to 1.5V.
How do you intend to produce the spike ?
Do you have the ESD "gun" ?
Amnon
"Dummy" <ahkit1021@yahoo.com> ???
??????:74bb84c0.0408122215.7c69218a@posting.google.com...
> Radio reset when ESD was applied to certain exposed conductive pins.
> I would like to monitor the reset pin of the microcontroller using
> oscilloscope, but worrying that ESD spike might damage the scope which
> has 250V max rating. Is oscilloscope fast enough to capture ESD spike?
> What equipments or test setup are needed in order to capture ESD
> spike? Thanks.
- Next message: Pooh Bear: "Re: ESD level measurement"
- Previous message: andy: "Re: mosfet failure"
- In reply to: Dummy: "ESD level measurement"
- Next in thread: Pooh Bear: "Re: ESD level measurement"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
