Re: How to print my own PCB?
From: Bob Masta (NoSpam_at_daqarta.com)
Date: 10/05/04
- Next message: AA Institute: "Re: Water resistant motor"
- Previous message: Craig Hart: "Re: embedded chip question"
- In reply to: Rich Webb: "Re: How to print my own PCB?"
- Messages sorted by: [ date ] [ thread ]
Date: Tue, 05 Oct 2004 12:25:19 GMT
On Tue, 05 Oct 2004 01:49:16 GMT, Rich Webb
<bbew.ar@mapson.nozirev.ten> wrote:
>On Tue, 05 Oct 2004 00:16:34 GMT, "Carl Gilbert"
><mr_carl_gilbert@hotmail.com> wrote:
>
>>Hi
>>
>>I am looking to build a basic heating system using the attached design. It
>>incorporates a 555, a variable resistor, some diodes and other bits and
>>pieces I don't understand but soon will.
>>
>>The only problem is finding/making a board for it. I made a board in school
>>once where we used some sort of pen to draw the outline and dipped the thing
>>in acid.
>>
Complete instructions and lots of tips on how to do that are at
<www.daqarta.com/lptxh.htm>
Best regards,
Bob Masta
dqatechATdaqartaDOTcom
D A Q A R T A
Data AcQuisition And Real-Time Analysis
www.daqarta.com
- Next message: AA Institute: "Re: Water resistant motor"
- Previous message: Craig Hart: "Re: embedded chip question"
- In reply to: Rich Webb: "Re: How to print my own PCB?"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
