Re: female 3.5mm to dual female RCA

From: Rich Grise (richgrise_at_example.net)
Date: 01/04/05 

Date: Tue, 04 Jan 2005 00:35:32 GMT

On Sun, 02 Jan 2005 12:49:53 -0800, Walter Harley wrote:

> "Pasquale" <spdrweb@NOTHNXtelusplanet.net> wrote in message
> news:jBXBd.45974$KO5.45393@clgrps13...
>> I'm going to buy another 3.5mm jack for my adaptor and do a better
>> soldering. Now that I take a closer look at it, it's not so great.
>> Thinking about, I remember the tabs getting too hot because the tabs were
>> moving back-and-forth in the plastic core. I'm going to be more careful
>> this time.
>>
>> Hopefully that will fix the problem. If not I'll try a repair shop or
>> Radio Shack and see what they have to say.
>
> Based on everything you said - I suspect the problem is just a combination
> of inappropriate preamp and defective soldering.

>From what I've been able to glean, it sounds like he's trying to put a
mono mic into right and left of a stereo preamp simultaneously, in which
case he has "The Jack" wired wrong. All three center conductors should be
connected, and all three shells should be connected, and if there's a
third contact on any of them, it's the wrong part.

The thing he's trying to make is called a "Y-adapter".

Good Luck!
Rich

Relevant Pages

  • Re: female 3.5mm to dual female RCA
    ... I remember the tabs getting too hot because the tabs were ... > of inappropriate preamp and defective soldering. ... case he has "The Jack" wired wrong. ...
    (sci.electronics.components)
  • Re: 1978 super reverb
    ... for some reason that particular amp doesn't yet have the ... the jack and sometimes cold soldering on the wire leads to the jack. ...
    (alt.guitar)
  • Re: HP Pavilion Laptop Owners with Bad Power Jacks....
    ... a power jack replacement on my HP ZE1250. ... pieces of metal that were in the soldering points came out easily. ... Plugging in the power adapter: When I tested the adapter in the jack ...
    (comp.sys.hp.hardware)
  • Re: Working with a tab-delimited input file
    ... Jack Sleight wrote: ... > Hi tofu, ... I think his I/O routine is killing the tabs and repositioning his data to ...
    (comp.lang.cobol)
  • Re: bandspread tuning tutorial?
    ... Do you know a tech' or ham' in your area that can do the soldering? ... Just make a hole in the back cover for the RCA jack and run the coax from the jack to the oscillator circuit. ... display to the receiver but it would be better to install a jack (RCA ... would allow you to use it with another receiver. ...
    (rec.radio.shortwave)
Quantcast