Re: Voice annunciated test box circuitry

From: mirach (mirach9320_at_cox.net)
Date: 02/18/05 

Date: 17 Feb 2005 21:12:42 -0800

Thanks guys for the great responses . I could actually get by at
present with 128 individual numbers. (we currently arnt working on the
units with 256 wires). Some of the involved electronics is beyond my
scope of knowlege, so im not against paying someone to put a couple of
these together if a price could be worked out that we both could live
with. I could even send you the empty boxes probably 8"Wide by 6"
high by 2" deep. and they would probably be assembled without the plug
(we can wire the actual plugs) so basically its making the boards and
chips work then I can take it from there. I like the idea of a portable
device ,this is the way our current light boxes are and it would be a
plus to be portable. I had originally wondered if you might be able to
get 128 small cheap 1 or 2 second voice chips that could each be
triggered by a voltage when that wire is touched . But I may be
dreaming on that one :) . I was originally thinking of these chips
replacing the LEDs currently in the boxes. That may be too simplistic
of an idea since im not sure whats avialiable. Let me know what you
think guys. And again Thank You

Relevant Pages

  • Re: pre-wire home - best practices?
    ... wire to all speaker runs. ... Box two was near the entrance light switch area at switch ... out to the wall speakers. ... As for using boxes vs mud plates, ...
    (comp.home.automation)
  • Re: Outside Wiring With PVC Pipe ?
    ... > the wires inside from where they come thru the house siding to a few feet ... > where the PVC tubing and fittings would be hugging the outside house wall ... > Regarding those Bell electrical outdoor junction boxes: ... > for the wire to go thru. ...
    (alt.home.repair)
  • Re: My wiring job.
    ... Just B4 it enters the box, wire should have some loop(7 inch or so extra ... only have 1.5" to play with, that's why I used those boxes. ... They have raised tabs on them for nailing purposes so it would be difficult to slip them between wallboard and a stud. ... In your case since the cable passes through the wood studs so close to the boxes, additional stapling is probably not necessary. ...
    (alt.home.repair)
  • Re: MWS Stellar Wars no display not starting
    ... Your correct on the 1J3-4 blue/white wire it is same in my game. ... I might have toasted the new roms. ... CAPS that the 3 prom chips need to be in place when swapping flipper ...
    (rec.games.pinball)
  • Re: Very short range bidirectional RF link.
    ... Any chips or modules suitable ?. ... so you'll need both a transmitter and a receiver ... (1/4 wavelength wire works well. ... solution (see rfPIC on the microchip site). ...
    (sci.electronics.design)