USB Cable Soldering

kimberly.shaffer_at_gmail.com
Date: 02/19/05 

Date: 18 Feb 2005 16:32:48 -0800

My bunny chewed through my USB cable on my Wacom tablet, is it possible
to solder it back together so that it will work? I have never soldered
anything before, but it seems likely. It costs 48.50 to send it back
to the manufacturer and have them replace the USB connector so it seems
cheaper to have it soldered or do it myself.

Thanks!

Kimberly

Relevant Pages

  • Re: DEAD MAXTOR! HELP!
    ... if you can work out how to get inside the housing. ... It isnt that hard to replace the USB connector if you can solder. ... could have just rammed the center plastic post of the usb female ...
    (comp.sys.ibm.pc.hardware.storage)
  • Re: DEAD MAXTOR! HELP!
    ... if you can work out how to get inside the housing. ... It isnt that hard to replace the USB connector if you can solder. ... could have just rammed the center plastic post of the usb female ...
    (comp.sys.ibm.pc.hardware.storage)
  • Re: Breakaway cable acting up
    ... find anyone who know solder near your house, any electronic repair shop ... it will be much cheaper :-) ...
    (rec.arts.movies.production.sound)
  • Re: Anyone wants to make money by soldering?
    ... It would be cheaper for me to pay a little bit rather than buy a ... tiny soldering device, solder, microscope etc. ... use some liquid flux. ...
    (sci.electronics.design)
  • Re: USB Cable Soldering
    ... >to solder it back together so that it will work? ... It costs 48.50 to send it back ... >to the manufacturer and have them replace the USB connector so it seems ... enough insulation from the conductors (prob about 3/8 inch). ...
    (sci.electronics.basics)
Quantcast