Re: Bought a house with a Fuse Box. Should I replace with a Circuit Breaker?

From: Kitchen Man (nannerbac_at_yahoo.com)
Date: 02/19/05


Date: Sat, 19 Feb 2005 15:28:48 -0700

On Fri, 18 Feb 2005 10:56:41 -0800, "Larry Brasfield"
<donotspam_larry_brasfield@hotmail.com> wrote:

>
>> My question is, should I upgrade the fuse box and replace it with a
>> circuit breaker. If I did so, would I need to replace every wire in my
>> entire house or could I just run a ground wire up to every outlet and
>> install a 3 prong outlet?
>
>That is a question about local code. From a safety
>standpoint, your separate ground wire should work
>provided the diameter is larger (smaller AWG). If you
>are going to get into the walls, why not just install regular
>3-wire romex?

That was my thought as well. If you're going to go through the trouble
to pull wires, you might as well replace the old stuff. Replacing the
old wire can make the job easier; the old stuff can be used in place of
a "snake" to pull in the new wire as the old is pulled out. The big
problem with that approach is having large enough diameter holes to
accommodate the attachment point of the new wire to the old. You've got
to make a good solid attachment, and don't overuse force if the cable
pull gets stuck. I'd make it a two-man job, one pulling the old wire,
one guiding the new.

--
Al Brennan


Relevant Pages

  • Re: Best wire crimper
    ... but not so much as to weaken the wire. ... leading to early failure in pull conditions. ... then the pull test done again to verify that the adjustment was done ... closing of the crimp jaws. ...
    (rec.crafts.metalworking)
  • Re: Pulling HDMI Cable
    ... tape to run the pull wire then wrap the HDMI cable to the pull wire. ... recently pulled all cables out of this conduit (S-Video,Composite, ...
    (alt.tv.tech.hdtv)
  • Re: Pulling fine wire through sleeving query
    ... Some 0.3mm nichrome heater element wire ... sufficient strength overlap join to pull 1 wire through but I doubt it ... constricted pulls should be done dry, eg silicone oil hinders, so I'm ... stidd wire threaders for existing conduit runs. ...
    (sci.electronics.repair)
  • Re: Burying video/audio intercom to front gate
    ... I-com actually runs on 22GA stranded wire, but it's delicate wire and I ... lamp post is not meant to really function as a lamp - it's there to mostly ... solid even on a straight pull, ... then go entirely wireless with intercom, video, gate control, motion ...
    (alt.home.repair)
  • Re: AVC Media Players
    ... the wiring takes many 45 and 90 degree bends as it snakes it way from floor ... to apply any crimp or compression on the wire itself. ... the bends make the job of using one wire to pull another quite unpredictable ... pull the new stuff. ...
    (rec.video.desktop)