Re: 555 used as a delayed pulse generator?



In article <69GOe.31777$ll3.404429@xxxxxxxxxxxxxxxxxxxxxxxx>, Tristar wrote:

> I'm looking to set us a simple way to turn something on after 10 seconds. The
> resulting output after the end of the 10 seconds needs to be a momentary pulse
> and not stay in a closed position.
>
> -----------------------------------------------------------------------^-
>
> Like this.
>

set up the 555 as a monostable and use a capicitor in series with the output
to pulse the transistor's base when the output changes state after the 10
seconds have elapsed. (there'll bve a pulse to the transistor when it starts
too but it'll be the wrong polarity and the transistor will ignore it)

--

Bye.
Jasen
.



Relevant Pages

  • Re: PMOS in parallel with NMOS
    ... Take a PNP bi-polar transistor. ... Now obviously, in everyday life, you put a resistor going into the ... it's OK because the pulse width and duty cycle are low enough that it ...
    (comp.arch.embedded)
  • Re: web site feedback (HV driver)
    ... I can use an avalanche transistor for asymmetrical drive, ... But it has the downside of a lot of jitter when exact pulse repetions ... My suggestion was to use a B/W television flyback tube. ...
    (sci.electronics.design)
  • Re: web site feedback (HV driver)
    ... I can use an avalanche transistor for asymmetrical drive, ... But it has the downside of a lot of jitter when exact pulse repetions ... My suggestion was to use a B/W television flyback tube. ...
    (sci.electronics.design)
  • Re: web site feedback (HV driver)
    ... But it has the downside of a lot of jitter when exact pulse repetions ... You can do surprising thinks with a hunk of coax and a relay, ... Or with a transistor and coax if trigger timing does matter :-) ...
    (sci.electronics.design)
  • Re: Making an X-10 lamp module immune to dimming
    ... I was thinking along the lines of a diode and cap too. ... However, if there is always a pulse there, a simple ... diode - capacitor network into the transistor would trigger the triac early ...
    (comp.home.automation)