Re: what would happen if...
"dudeguy" <ftw_guitar@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:ocWdnaVE1uin_87eRVn_vA@xxxxxxxxxxxxxxx
> what would happen if a 24volt 1000mA power supply was used to power an
> 18v device?
>
What current range is needed by the device at 18VDC? This is important to
know.
Don't connect gismo before you have regulated the 24VDC to 18VDC with a
proprietary 3-pin chip attached to a heatsink as necessary.
Jim
.
Relevant Pages
- Re: IBM ps2 Micro Channel Soundblaster
... > Unfortunately the heatsink fell off and I pulled the chip to repair the ... Prev by Date: ...
(comp.sys.ibm.ps2.hardware) - Re: Startup Circuit for CMOS current source
... >Hello Jim, ... >> Takes some VERY BIG resistors. ... >I am not a chip guy but wouldn't it be easy to turn that resistor off ... Prev by Date: ...
(sci.electronics.design) - Re: Copied files do not match originals
... You want it to be error free, ... the provided heatsink and the chipset chips. ... a high chip temperature is the result. ... my previous motherboard had no heatsink, ...
(microsoft.public.windowsxp.general) - Re: Northbridge chip cooling (not)
... rip the chip to shreds. ... some wire shoved through the holes, to bind the heatsink ... to meet the max case temp of the chip. ... The max case temp for some of these IC packages, ...
(alt.comp.periphs.mainboard.asus) - Re: Help!Oblivion just fucked up the Xbox!
... When this happens, the heatsink can't do ... its job as well, and the chip overheats. ... They must be using some pretty crappy solder, that's all I got to say. ... you have made so many stupid ass posts in past posts that ...
(alt.games.video.xbox) |
|
