Has my PIC blown?
- From: "Silverfox" <silverfox.williams@xxxxxxxxx>
- Date: 18 Nov 2005 04:32:07 -0800
Hello there all,
I am sort of new to the electronic world and wondered if any of you
could help.
I have a PIC16F84 and written a simple program to just turn on PIN RA0
which is attached to an LED.
Pin 4 (MCLR) is connected to a capacitor wich then goes to ground.
Pin 5 is to ground.
Pin 14 is to 5V.
Pin 17 and 18 are to an Oscillator of 4MHz.
Pin 19 is to and LED to ground.
My configuration bits are:
Oscillator : XT
Watchdog Timer : On
Power up timer : Off
Code Protect : Off
Please excuse me if any of my terminology is incorrect as I am still
learning.
I have tested the code in simulation mode and the STATUS, TRISA and
PORTA registers seem to be set correctly.
The LED doesn't come on? Should I post my code?
Could somebody point me in the right direction?
Thanx very much in advance
Richard
.
- Follow-Ups:
- Re: Has my PIC blown?
- From: Quack
- Re: Has my PIC blown?
- From: Anthony Fremont
- Re: Has my PIC blown?
- From: Anthony Fremont
- Re: Has my PIC blown?
- Prev by Date: Re: LED Christmas Lights
- Next by Date: Re: Autocorrecting multimeter?
- Previous by thread: Somethings about semiconductor devices parameters extraction software-Aurora
- Next by thread: Re: Has my PIC blown?
- Index(es):
Relevant Pages
|
