Re: Ink jet printer

From: Jamie <jamie_5_not_valid_after_5_Please@xxxxxxxxxxx>
Date: Sat, 19 Nov 2005 21:19:00 -0800

Rodney wrote:

Will an ink jet printer work for printing out artwork on a transparency for PCB exposure? I've been told it must be a laser printer but maybe someone has some experience with this.

Thanks Rod.

i find that using photo ink jet paper in my laser printer
works well, i iron it on and then hit it with water
.. the solution in the ink jet is water based i guess
and loosens up real nicely leaving the toner on the
copper clad.
  i have also did this on clear mylar instead of
copper clad. it does work but i find that the
heating process sometimes can distort the mylar.


--
Real Programmers Do things like this.
http://webpages.charter.net/jamie_5

References:
- Ink jet printer
  - From: Rodney

Prev by Date: Re: 18 volt charger
Next by Date: Re: Use of Extension Cord
Previous by thread: Re: Ink jet printer
Next by thread: One giga ohms resistor
Index(es):
- Date
- Thread

Relevant Pages

Re: NASA: "Water on the Moon!" This is the Shameless Science!
... The container could be a lightweight polymer - perhaps even mylar.. ... maybe 10 pounds. ... The idea is to trap evaporation caused by solar heating in-situ. ... The evaporated water could be trapped by a hefty trash bag with dirst ...
(sci.space.policy)
Re: Mylar sheet
... light soapy mixture, I'd just spend the few bucks and use the correct stuff. ... I may have some alcohol in it too, seems to dry quickly too. ... We've used just tap water and spray mister for laying down overlays. ... Have not tried this with clear mylar film on our playfields as we simply have two people do the laydown. ...
(rec.games.pinball)
Re: How to reapply Mylar in high traffic areas...
... So the wax UNDER the mylar glue wont cause any ill effects?! ... Now, do I use water, soapy water or Windex to lay ...
(rec.games.pinball)