Re: Has my PIC blown?

Hello there all again

Ok then, I am using MPLAB IDE 5.62 and PICSTART Plus Development
Programmer.

I have some succes, thank you very much, to all of you.

What I have got is:
Configuration Bits:
- Oscilator: XT
- Watchdog Timer: Off
- Power Up Timer: On
- Code Protect: Off

Pin 4 MCLR I have attached to the output of the voltage regulator via a
4.7K ohms resistor.
Pin 5 to ground
Pin 14 to the output of the voltage regulator.
Pin 15 and 16 to the oscilator. Oscilator middle pin is to ground.
Pin 17 to cathode of LED via a 270 ohms resisitor.

I haven't put the capacitors on the input and output of the voltage
regulator yet. Are these put on to keep the voltage smooth in and out
of the voltage regulator?

I have changed the code slightly too, so that PORTA and PORTB bits are
all set to 1 and I change PortA Bit0 to a 0 to turn on my LED.

Next step is for me to attach another LED and get it to flash every so
often.

Thank you very much again for your help.
Richard

.

Relevant Pages

  • TECH: System 6 +5 reading High
    ... I just rebuilt the power supply in my System 6 Time Warp. ... the correct reading for the 100v section: 12.60 volts on pin 6. ... when I read the +5 section I'm getting 12.06 volts on pins 7-10. ... If I replace the voltage regulator I guess this is what I need: ...
    (rec.games.pinball)
  • Re: TECH: System 6 +5 reading High
    ... I just rebuilt the power supply in my System 6 Time Warp. ... the correct reading for the 100v section: 12.60 volts on pin 6. ... when I read the +5 section I'm getting 12.06 volts on pins 7-10. ... If I replace the voltage regulator I guess this is what I need: ...
    (rec.games.pinball)
  • Re: Has my PIC blown?
    ... Watchdog Timer: Off ... Pin 5 to ground ... Pin 14 to the output of the voltage regulator. ... Oscilator middle pin is to ground. ...
    (sci.electronics.basics)
  • Re: Has my PIC blown?
    ... and off via pin 17 and I am keeping a green LED turned on, ... So both the anodes of the LED goes to the output pin of the voltage ... I put a 270 ohms resistor in series and the red LED flickers ... pin of voltage regulator and this clears up the flickering. ...
    (sci.electronics.basics)