Re: Transmission Gate question



Angmor wrote:

> Something I didn't make entirely clear.... I don't understand how they
> can just state that the output voltage follows the input voltage
> closely. Where is the justification? This is the real problem I'm
> having.

When the fets are on clearly this must be the case ( assuming the load is
much greater than the fets' on resistance of course - which is how you use
these things ).

Graham


.

Relevant Pages

  • Re: variac question?
    ... circuit with its output voltage set to 30% of input voltage, ... the breaker. ... When I set it to 100% of output voltage, however, it didn't pop ... You didn't say whether your variac is a 0-100% kind or the kind which can output more than 100% of the input voltage. ...
    (rec.crafts.metalworking)
  • Re: variac question?
    ... Grant Erwin wrote: ... the breaker. ... When I set it to 100% of output voltage, however, it didn't pop ... You didn't say whether your variac is a 0-100% kind or the kind which can output more than 100% of the input voltage. ...
    (rec.crafts.metalworking)
  • Re: Best approach for a wide-range (10:1) SMPS
    ... transients to perhaps 100V) operation? ... At the very top of the input voltage range the frequency will need to ... You don't mention what your output voltage quality needs to be (ripple ...
    (sci.electronics.design)
  • Re: variac question?
    ... its output voltage set to 30% of input voltage, ... the breaker. ... When I set it to 100% of output voltage, however, it didn't pop ...
    (rec.crafts.metalworking)
  • Re: 24W DC to DC converter
    ... I want to design a DC to DC converter. ... The input voltage range includes the output voltage, ... See, for example, Maxim ...
    (sci.electronics.design)