Re: Carbon microphone amplitude
- From: Don Bowey <dbowey@xxxxxxxxxxx>
- Date: Mon, 27 Feb 2006 08:43:12 -0800
On 2/26/06 1:50 PM, in article
Xns9776E8563A47Dblattersplatterlatte@xxxxxxxxxxxxxx, "Rune D. Jørgensen"
<RUNE_dahl@xxxxxxxxxxxxxxxxxxxxxx> wrote:
Hi.
I'm building a microphone amplifier and filter for a communication system
for my motorcycle. I'm filtering away frequencies below 1KHz to suppress
wind noise.
I have a microphone that has a resistance of 1.8K ohm, so I guess it's a
carbon. I have read somewhere that I should have approximately 1mA running
through it. Is that correct and what kind of amplitude should I expect out
of the microphone?
I don't believe that is a carbon mike. I may not be up-to-date on them, but
in my experience carbon mikes tend to have a resistance of 200 Ohms or so.
In practice the current could be 10 milliamps, more or less, and the
resulting signal from a good quality unit might be as much as 0.5V with a
circuit voltage of about 4 to 6V.
Don
.
- References:
- Carbon microphone amplitude
- From: Rune D. Jørgensen
- Carbon microphone amplitude
- Prev by Date: Re: Capacitor charging
- Next by Date: Re: 16 bit eeprom
- Previous by thread: Re: Carbon microphone amplitude
- Next by thread: Re: Carbon microphone amplitude
- Index(es):
Relevant Pages
|