Bad design?

Is this a bad design:

I have 5 connections (switches on a X10 mini home controller) that either
need to get shorted with pin A or pin B.

I am planning on using two CD4066 bilateral switches
(http://www.fairchildsemi.com/ds/CD/CD4066BC.pdf).

Each of the 5 inputs would have TWO connections connected to it, one from
pin A and one from pin B (outputs of two of the 'spare' switches). As long
as I am careful not to have both switch A and switch B enabled at the same
time is this a bad design?

I know that I could use an inverter to protect against having both A and B
active at the same time, but I am going to use a PIC to control the
switching. In an effort to keep parts to a minimum I can do this with
careful coding.

Thanks


.

Relevant Pages

  • Re: Marshall 6100 switching problems
    ... The midi board board where the switches are decoded and processed: ... apply the VCC to that processor. ... Check pin 11 with a scope. ... The amp behaves normal for the rest of the time... ...
    (alt.guitar.amps)
  • Re: Need help with a Black knight problem
    ... flowed the solder at every pin on both boards including all the pins ... from the plug in the backbox to the switches on the coin door. ... most likely have a short to ground on the row wire. ... impossible...Can a bad diode on just none of these switches make the ...
    (rec.games.pinball)
  • Re: Bad design?
    ... I have 5 connections (switches on a X10 mini home controller) that either ... need to get shorted with pin A or pin B. ...
    (sci.electronics.basics)
  • Re: WPC-95 Problems
    ... switches - and still nothing. ... Then check AC leaving the AC and AC arriving at the driver board. ... removing the backbox (including unplugging all connectors) - which I ... Pin 2 = -101.1V ...
    (rec.games.pinball)
  • Re: Autoview switching on PVR
    ... control of the TV stopping me watch the program I wanted to watch. ... if the pin being used by the sky box as changed, ... > SCART pin 8 switches your TV to the Ext. channel when you turn on the ... On the VCR SCART pin8 is activated when Autoview changes the ...
    (uk.tech.tv.sky)