Re: help with 555 schmitt trigger resetting



Whoops, I meant change R2 to 100k and leave R1 at 220k.
--
john

Thanks john, I'll try that.
The TIP42's also drive a LED with 1k resistor, could the 10v on this
resistor when the lights are on be used to somehow reset the trigger?

.

Relevant Pages

  • Re: How to count pulses per second ?
    ... There you go again John, ... You're a PIC programmer so that puts you at the forefront of ... why should he have to post a design to ... resistor, and an LED, no? ...
    (sci.electronics.basics)
  • Re: 431 shunt regulator help
    ... to use a TI431 to sense anything above 9 or 10 volts, ... eg; current resistor on Vin. ... If you were to tell us which A/D converter you were ... John Larkin is not only thin-skinned in his own right, ...
    (sci.electronics.design)
  • Re: Why extreme S-parameter values
    ... >> resistor in parallel with a small capacitor. ... John. ... I'm impressed by both the VNA accuracy and by the high collector ...
    (sci.electronics.design)
  • Re: Low Current Measurement (without ammeter)
    ... John O'Flaherty wrote: ... measures voltage from 0 to 10V. ... resistor "shunt" is placed in series what kind of accuracy can be ... compliance to handle the extra resistance. ...
    (sci.electronics.basics)
  • Re: Capacitor-feedback for low noise
    ... John and Joerg, no, I don't think I can use a JFET to discharge, ... is equal to the shot noise from a few tens of fA. ... A resistor across the capacitor to discharge it continuously is no good ...
    (sci.electronics.design)