Re: splitting voltage

On Wed, 23 Aug 2006 20:56:12 GMT, ehsjr <ehsjr@xxxxxxxxxxxxxxxx>
wrote:


I've drawn up a schematic...

http://img217.imageshack.us/my.php?image=circuitcs2.jpg

I've changed the supply to 2x C batteries, and added a diode in
parallel to the motor.

Do you think this would work?

Two other things you left out the connection between pin four and the
positive supply rail, both drawings, and it is good practice to put a
cap between pin five and ground to keep the timing stable

----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----
.

Relevant Pages

  • Re: Calculating resistors required
    ... > batteries). ... > guess you're suggesting a diode also drops the current. ... >> current to drive your motor. ... You need to know the current to calculate the dropper resistor. ...
    (sci.electronics.basics)
  • Re: splitting voltage
    ... I've changed the supply to 2x C batteries, and added a diode in ... Add the recommended capacitor ... pin 8 to pin 4). ... the motor, with the banded end to the + side. ...
    (sci.electronics.basics)
  • Re: Controlling a motor with a transistor and a PIC
    ... I'm ignoring the speed of the motor and just trying to ... With this design I need to put the pin low in order to turn the motor ... resistor and a 1N4001 diode across the motor. ... You will be much better off to use a power mosfet as shown at the ...
    (sci.electronics.basics)
  • Re: Controlling a motor with a transistor and a PIC
    ... I'm ignoring the speed of the motor and just trying to ... With this design I need to put the pin low in order to turn the motor ... resistor and a 1N4001 diode across the motor. ... You will be much better off to use a power mosfet as shown at the ...
    (sci.electronics.basics)
  • Re: Arcam Alpha 9 amplifier
    ... Motorised switch for R/C use and also manual front panel knob. ... trouble with extra back torque and driving round via the motor. ... If pin 1 is on motor side of each switch wafer ... Eventually found the first problem to be the second cog is worn ...
    (sci.electronics.repair)