Re: Laser tagging (homemade laser tagging game)



On Sun, 10 Sep 2006 16:18:21 +0200, "Bart Bervoets" <nekobe@xxxxxxxxx>
wrote:

After playing laser tagging for a few weeks, i was wondering if it would be
possible to design a simple
version of the equipment for practice purposes.
Pulsing a laser pointer should be not so hard but i'm not so sure of the
receiver end.
Ideal would be the following:

Sender, laser pointer built into toy gun, trigger will allow pointer to
pulse for a quarther second
and then go off, repeated pulling of trigger will cause pulses but never a
continues beam.
Receiver end will start beeping and/or flashing for 4 seconds when hit, gun
would always be connected to receiver and
would be disabled during the 4 seconds of being hit.
I know the equipment is available but very expensive, and it should be
possible to create this.
Eventual option would be a player hit counter, but that's not important at
this stage.
Any suggestions?

Bart Bervoets

Greetings Bart,
You could use any cheap IR remote control to pulse the laser. You can
buy IR remote control kits. You can build your own reciever using the
info from this link:
http://www.epanorama.net/pdf_redirect.php?url=http://www.imagineeringezine.com/PDF-FILES/40krvr1.pdf
You can use the output that pulses the IR LED to pulse your laser
pointer. Since the laser is pulsed at 40kHz and your reciever is made
to only recognise this frequency it will ignore ambient light. You can
use a 555 timer circuit to turn on the remote for the 1/4 second
requirement. The reciever can be used to trigger another 555 timer
circuit to disconnect power to the firing circuit for the 4 second
requirement. Google for IR remote control and 555 timer circuits.
There is a ton of info on the web about these.
ERS
.



Relevant Pages

  • Re: Length definition in SR - can anyone explain
    ... I'm in an inertial frame. ... The moving observer measures the length of one pulse to be much less ... moving frame. ... The leading edge of edge of each laser pulse leaves the ...
    (sci.physics.relativity)
  • Re: Length definition in SR - can anyone explain
    ... I'm in an inertial frame. ... The moving observer measures the length of one pulse to be much less ... moving frame. ... The leading edge of edge of each laser pulse leaves the ...
    (sci.physics.relativity)
  • Re: Q: average power measurement with photodiode
    ... He said that in order to measure the average power of pulsed laser the ... laser (fs to us pulse duration, single shot to high repetition rate). ... an integrator in the readout electronics. ...
    (sci.optics)
  • Re: Laser ranging to moon begs questions
    ... >Pulsed ND Yag laser, pulsed at 10 Hz with a 200 ps duty cycle. ... says "final beam diameter .75m ". ... The angular spread of the returning pulse is ... return several photons per pulse. ...
    (sci.astro)
  • Re: Length definition in SR - can anyone explain
    ... I'm in an inertial frame. ... The moving observer measures the length of one pulse to be much ... As I stated in the problem I have a laser pointed along the ...
    (sci.physics.relativity)