balancing sensors
Hi all,
I am building a sensor cicuit, 2 sensors. Simple sensor with Vdd, GND
and Vout.
The too sensor are read by my microchip. but the voltage out of the two
sensor are not identical under the same conditions. What is the best
way to make them eual.
I tried using a 3 legged potentiometer (voltage divider). I did not
work well, one of the value with the highest resistance stays at the
same output no mater what input (light). maybe just putting one
resistor on one of the output sensor.
Any better ways ?
thanks
ken
.
Relevant Pages
- Fluke 867 is my favorite voltmeter
... opportunity to see a Toyota Wide Range Air:Fuel sensor yet? ... Wide Range Air:Fuel sensor output voltage. ... oxygen content of the exhaust decreases. ... Channel 1 is connected to a current probe clamped around one heater wire, ...
(rec.audio.tubes) - Re: Sensor/LED circuit-more help needed please-multiVs and dimmer
... > I am still working on this Sensor Circuit with LED indicators. ... > appropriate voltage. ... > The LEDs are supplied directly by the sensors. ... a transistor current source is a fairly good "one-trick pony" ...
(sci.electronics.basics) - Re: QBASIC racetrack timer glitch
... When a sensor is conducting, ... They all showed a change of voltage. ... The voltage at the comparator should be 0 ... all have a common reference voltage and that there would be ...
(comp.programming) - Re: Hall Effect Sensors
... I'd like to interface Hall Effect sensor to a uC and have picked out the ... produce a voltage of 625mV at 1G when the supply voltage is 5.0V? ... The nominal output of the sensor you're looking at is around 1/2 Vcc ...
(sci.electronics.basics) - Re: Hall Effect Sensors
... On Apr 8, 9:36 am, "Michael" ... I'd like to interface Hall Effect sensor to a uC and have picked out the ... produce a voltage of 625mV at 1G when the supply voltage is 5.0V? ... The nominal output of the sensor you're looking at is around 1/2 Vcc ...
(sci.electronics.basics) |
|
