Re: Can Some1 Tell How can I construct a simple Amplifier Using BJT Which Gives 80 gain



Yeah I guess I did I have used 2n3904 transistor but i cant fiqure out
a way to construct it .... My circuit is not giving any gain

Regards,
Arafat Safdar

Biasi wrote:
<attractivearafat@xxxxxxxxx> wrote in message
news:1164553640.131718.240090@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Can Some1 Tell How can I construct a simple Amplifier Using BJT Which
Gives 80 gain . yeah the frequency range should be atleast 1000
hertz ....... i can use Common collector , Common emitter , Common Base
(transistors), resisitors of course and capacitors .....Sounds like
everything...........Anyways can Some1 Give me the circuit or atleast
tell me how to construct 1


Regards,
Arafat Safdar


Did you look for any?

.



Relevant Pages

  • Re: Transistor biasing
    ... >I keep reading that in order to properly bias a transistor, ... >the emitter and have negative feedback stabilize the gain. ... The base voltage is .6 volts higher than the ...
    (sci.electronics.basics)
  • Re: MRC Ampack upgrade: Attn electronics froods
    ... The Fairchild data sheet for the TIP120 gives a gain of 1000, that means all devices will have a gain of at least 1000, and plenty of them will have a gain of 3000. ... This means a resistor that protects a low gain transistor won't protect a high gain device. ... The resistor that protects a high gain device will lower the performance of a low gain device. ... Let's guess a good heatsink could hold the transistor case temp down to 75 C, allowing the device to survive 36 watts. ...
    (rec.models.railroad)
  • Re: The most simple amplifier
    ... The schematic I drew is class A. Any transistor amplifier where the ... to control how much gain you have and more difficult to bias properly. ... drive an 8 ohm speaker with a common-emitter transistor circuit (that's one ... common-emitter stage to give voltage gain, ...
    (sci.electronics.basics)
  • Re: choosing a suitable transistor
    ... Will this transistor work instead: ... Lists the maximum DC collector current at 3 amps. ... gain at the load current that is at least half the peak gain shown on ... Checking the saturation voltage, it is about 300 mA for a saturation ...
    (sci.electronics.basics)
  • Re: Transistor biasing
    ... > I keep reading that in order to properly bias a transistor, ... > Hfe between 25 and 300. ... So the solution is to put a resistor before ... > the emitter and have negative feedback stabilize the gain. ...
    (sci.electronics.basics)