Re: wireless receiver


"lerameur" <lerameur@xxxxxxxxx> wrote in message
news:1164589146.605543.305610@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Hi,

I received this TWS-434A/RWS-434 8-Bit RF Combo Package and been
playing with it. I am sending and receiving using pics.
My sending signal somewhat differs with my receiving signal. I hook up
both signals on the oscilloscope and I get this clear but different
signal, Here is a picture I posted of the signal:
http://www3.sympatico.ca/lerameur/
It seems that the receiving signal cannot stay on more then 125ms,
anyone can tell me why and how to fix it ?
the baud rate on the pic chip is at 2400 and the frequency if the
signal is at 433mhz as mentionned above

thank you

ken


Have you got the baud rate wrong? 125ms is a long time. A start bit plus 8
data bits only lasts 9/2400=3.75ms at 2400 baud.


.

Relevant Pages

  • Re: Demodulating QPSK
    ... (This system is not especially useful for signals that occur in short bursts.) ... all filters were two-pole IIR filters. ... All of the critical frequencies were either a multiple or a fraction of the baud rate of the dibits. ... (This is the same frequency accumulator that is multiplied by 4 and used as the control frequency of the NCO in step (4). ...
    (comp.dsp)
  • Re: Demodulating QPSK
    ... (This system is not especially useful for signals that occur in short bursts.) ... all filters were two-pole IIR filters. ... All of the critical frequencies were either a multiple or a fraction of the baud rate of the dibits. ... Numerically Controlled Oscillator (NCO) running at 4x the frequency indicated by the frequency accumulator. ...
    (comp.dsp)
  • Re: serial communication problem
    ... The xx or yy values depends on the baud rate you use. ... >>I notice you have both the DTR and RTS controls disabled, ... >>device com port expecting? ... Some device will want these two line signals ...
    (microsoft.public.windowsce.embedded.vc)
  • wireless receiver
    ... My sending signal somewhat differs with my receiving signal. ... I hook up ... both signals on the oscilloscope and I get this clear but different ...
    (sci.electronics.basics)
  • Re: Linux, PC-based, PCI or USB oscilloscopes?
    ... Especially for a beginner I recommend a analog oscilloscope, ... purposes on _slow_ signals. ... sampling rate of at least 2*n, which is described by the Nyquist ...
    (comp.os.linux.hardware)