Re: Digital display for pressure sensor help needed

I am not sure if "it's too complicate for you" part and have no idea if
pressure sensors are cheap but all you are telling here sounds like
MicroController and some sensors. Take a look at following link. it's
unrelated to the your subject but it's again Controler and Sensors:


http://home.btconnect.com/PicAxe_Projects/WeatherMonitor/WeatherMonitor.htm



Homer


erikred7@xxxxxxxxx wrote:
I want to build a cuircut that will digitaly display air pressure
(0-200+ PSI) from 4 or 5 different sources on one small screen. Here
are my questions:

- Is this project feasible for someone with little knowledge of
electronics?

- Accuracy is not critical within a PSI or two would be fine. Would it
be simpler to use analog sending units or digital sensors?

- How would the cuircut work? Would it somehow take the signal from the
sensors and convert it to pounds per square inch and then send it to
something that would display that information on a LCD screen?

- What would be a rough estimate of the cost of this project?

Thank you,

Erik-

.

Relevant Pages

  • Re: Digital display for pressure sensor help needed
    ... Accuracy is not critical within a PSI or two would be fine. ... sensors and convert it to pounds per square inch and then send it to ... If you're a newbie looking for low cost, ... WAG total cost: $150 ...
    (sci.electronics.basics)
  • Re: Digital display for pressure sensor help needed
    ... Accuracy is not critical within a PSI or two would be fine. ... sensors and convert it to pounds per square inch and then send it to ... What would be a rough estimate of the cost of this project? ...
    (sci.electronics.basics)
  • Re: 2000 Eurovan camper beeps
    ... have 2 sensors one for low speed .3 psi and one for high speed 1.8psi. ... I went out to the van and reved the engine up in neutral to 2000 rpm.. ...
    (rec.autos.makers.vw.watercooled)
  • Re: Weight sensors.
    ... > digital bathroom scales, however no one seems to be suggesting this ... > Load cells seem to be the most common way of doing this, ... which directly conflicts with my goal of CHEAP. ... Going more upmarket, capacitive deadweight sensors, may also be practical. ...
    (sci.electronics.design)
  • Re: Burt Rutans plans for a manned mission to Mars
    ... :> student with life support (who still needs some sensors to tell what's ... :You completely ignore software issues with the "cheap" hardware you propose. ... :automating a task that's fairly trivial, and relatively cheap and easy, for ... maneuvering a heavy vehicle over unknown terrain. ...
    (sci.space.policy)