Re: Question About Series vs. Parallel Circuit, DC



mea305 wrote:
OK, I want to be sure I got this right. I did print one of the pages
offered by another respondent; but to ensure that I understand (I
certainly don't want to double the voltage and burn up the motor!), I
would think that the following would be correct:

1. If I take another set of batteries, connect them just as they would
be connected in the scooter (this is what I am referring to, by the
way), I would have two additonal batteries, connected, but yet to be
connected to the unit.

Yes. Each set of batteries would measure 12 volts.


2. At this point, would I merely connect the two positive poles
together, and then the two negative poles together --- and assume that
this would be the correct configuration?

If each set of batteries is the same voltage, then yes! this is how you
would connect them together. This is the correct configuration if you
want to double the capacity while keeping the voltage (12 volts) the same.


3. If I were to do the opposite, and connect the negative pole of my
first set of batteries to the positive pole of the second set, and do
the same for the opposite pole, would this be the correct manner, or is
number 2 (above) the correct means? Here, it is clear that I know not
the difference between the series and the parallel configurations; but,
I know "haste makes waste," and in this case, a "dead motor," which is
what I don't want.

Under no circumstances should you do this! Batteries can and sometimes
do explode and make an awful mess of anything around them. The
consequence of doing this could be worse than a dead motor.


Please advise; I appreciate the responses thus far; they have been
helpful, indeed!

Thanks,

Mark

FWIW, this is also the way you would jump-start an automobile. A second
12 volt battery would be connected to the vehicle's battery with plus to
plus and minus to minus. Still 12 volts, but greater capacity.

Chuck

chuck wrote:
mea305 wrote:
Suppose I have a 12 volt motor that operates on two 6 volt acid-free,
lead batteries; I was thinking that perhaps I could put to use at least
two extra batteries I have in an effort to increase the period of time
for power available on the motor. I am not certain, as I forgot, about
the differences between using a parallel circuit vs. a series circuit,
or, whether this is actually possible without causing harm to the
motor....

Therefore, could anyone tell me, first, whether this would be a good
idea; and then, if it would be, how I would configure the batteries to
ensure that I do not deliver more than the alloted 12 volts to the
motor?

I would appreciate it.

Thanks,

Mark

Not a bad idea at all. Connect the two spare 6 volt batteries in series
to make another 12 volt combination and simply place that in parallel
with the existing series pair of batteries. Providing the batteries
don't discharge each other (which is possible, but not highly likely)
you should be doubling the possible motor running time as you desired.

Chuck

----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----



----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----
.



Relevant Pages

  • Re: Solar-hydrogen home power system?
    ... > The down side may have you consider batteries instead. ... > The biggy for you will be that the voltage is not constant. ... you will need a switcher that is tailored for caps. ... To control a motor of any type efficiently, you really need some kind of ...
    (sci.energy.hydrogen)
  • Re: Solar-hydrogen home power system?
    ... > The down side may have you consider batteries instead. ... > The biggy for you will be that the voltage is not constant. ... you will need a switcher that is tailored for caps. ... To control a motor of any type efficiently, you really need some kind of ...
    (sci.energy)
  • Re: 3-phase AC motor control for battery-electric vehicle
    ... which means a 600v dc bus so lots of batteries as well. ... a few motors for low voltage. ... motor VAC rating, so a 208/240 VAC motor would require less batteries (380 ... controller, but the high voltage inverter option uses standard components. ...
    (sci.electronics.design)
  • Re: Electric Kontiki motor power supply and PWM questions
    ... voltage but wasn't sure about its effect upon current, ... I can vary the average current by adjusting the duty cycle. ... control the speed of the motor, ... The concern is not exhausting the batteries to the ...
    (sci.electronics.basics)
  • Re: Battery Source
    ... Yeah, it's maybe okay in small doses, flashlight ... batteries come to mind as being pretty safe if not swallowed. ... 12 volts DC is right at the maximum sane voltage. ...
    (rec.aviation.soaring)