Re: ATX power supply to drive a 12V DC motor?

Hi Eric,

I don't want to open the PSU. Can you give an alternative solution
please?

Regards,

Michael

Eric R Snow wrote:
On Fri, 05 Jan 2007 07:53:25 -0800, Eric R Snow <etpm@xxxxxxxxxxx>
wrote:

On 5 Jan 2007 05:36:38 -0800, "MK" <michaelkatsilis@xxxxxxxxx> wrote:

Hi,

I have a 12V DC motor (6A under load). The only power supplies I have
around here are ATX. Someone at an electronics shop told me they can be
used to supply the power, but I didn't ask how. Is it just a matter of
using an IDE connector to power the motor?

Regards,

Michael
Information from the January 2007 issue of Nuts and Volts column
called Electronics Q&A:
Connect a red wire and a black wire with a 10 ohm 5 watt resistor. If
there is a brown wire connect it to the orange wire. Connect the green
wire to a black wire with a switch. This is the on/off switch. Wired
as above the motor can be connected to a yellow and black wire and
turned on and off with a switch without damaging the power supply. If
you want the motor can be connected without a switch and the 10 ohm
resistor eliminated. Then the power supply on/off switch can be used
to turn the motor on and off. If you do this don't connect the red
wire to anything and don't disconnect the motor when the power supply
is on. Make sure all the unconnected wires cannot make contact with
anything. Here's a web site mentioned in the same column about ATX
power supplies:
http://web2.murraystate.edu/andy.batts/ps/POWERSUPPLY.HTM
All the above info was gleaned from Nuts and Volts and I cannot take
any credit for it.
ERS
WHOOPS! I forgot to add that if the load resistor is used it needs to
be mounted to a heat sink because it will get hot.
ERS

.

Relevant Pages

  • Re: Bridgeport boss 4 Spindle not powering up (continued)
    ... you need to reset a safety interlock on the motor switch pod ... I can work my way through the average power ... activate the spindle all he would get would be a buzzing sound. ... each for a different axis stepper motor drive). ...
    (rec.crafts.metalworking)
  • Re: Really stumped: PS inoperative
    ... When the front panel switch is depressed, the voltage drops to ... The grey PWR_OK wire on the main power connector reads zero after the PS ...
    (comp.sys.ibm.pc.hardware.misc)
  • Re: What can I replace this latching relay system with?
    ... Retrofitting a modern AC switch box if necessary would be ... The power wire is daisy chained. ... remote rotary controller. ...
    (comp.home.automation)
  • Re: electric motor forward/reverse wiring?
    ... after battling the available switch sections in the drum switch. ... need more wires between switch and motor, ... i'm impressed with your wire routing. ... I've seen electricians who would make similar mistakes. ...
    (rec.crafts.metalworking)
  • Re: Should I PID my Heat Exchanger?
    ... how did you bring power into the PID (a separate line ... I stole the power off the rotary power switch which is ... 16 gauge unstranded copper wire for the power to the controller and the ...
    (alt.coffee)