Re: ADC current requirement

Yes, something must be terribly wrong. You probably have the pin as a
digital output with a 0 written to the pin, and it's driving the load low
(or at least trying very hard to do so). An ADC input should be like any
other input and look like a fairly high impedance.

YOU WERE TOTALLY RIGHT! I WAS TOTALLY LOST.

When I put, on my opinion, pin to be digital out 0 it started to work
after that. So it seems that my 0/I is I/0 for rest of the world.
Thank you for your advise. I'd never would got it my self.

nogoodinel

.

Relevant Pages

  • Re: ADC current requirement
    ... a digital output with a 0 written to the pin, ... An ADC input ... I WAS TOTALLY LOST. ... When I put, on my opinion, pin to be digital out 0 it started to work ...
    (sci.electronics.basics)
  • naming convention for public/private words?
    ... \ set the state of a digital output pin ... pin get-control-reg to reg ...
    (comp.lang.forth)
  • Re: digital out cdrom to receiver
    ... It is a weird 2-4 pin connector though. ... If your receiver ... you need more than the around 2mA a standard digital output can supply. ...
    (comp.sys.ibm.pc.hardware.misc)
  • Re: Counting Bike Wheel Revs
    ... > The $1 sensors in the DigiKey catalog include a signal ... Three pins: Power, Ground, digital output. ... >> need is an input port pin and a pullup resistor. ... > sensor might be worth the extra $0.60. ...
    (comp.arch.embedded)
  • Re: ADC current requirement
    ... If you're saying that the ADC input pin is sinking 10mA of current, ... at the moment when I connect the lines, voltage drops heavily from ...
    (sci.electronics.basics)