Re: Tinning a solid copper bar.

eromlignod wrote:

Hi guys:

I'd like to tin one side of a 5/16" square copper bar so that it can
be soldered to a PCB. A soldering iron isn't doing the trick, even
with lots of flux. Any ideas?

Don


Solder pot.


--
Service to my country? Been there, Done that, and I've got my DD214 to
prove it.
Member of DAV #85.

Michael A. Terrell
Central Florida
.

Relevant Pages

  • Re: 0603 caps caps
    ... Flexing the cable to the board flexed the connector which in turn moved the metal cap of the capacitor. ... Most of the time, this came from flexing the PCB by an imperceivable amount, but until yesterday I had no noticed this happening from the solder cooling! ... I did not note if this was related to the soldering iron temperature. ...
    (sci.electronics.design)
  • Re: Tinning a solid copper bar.
    ... I'd like to tin one side of a 5/16" square copper bar so that it can ... A soldering iron isn't doing the trick, ... PCB is a no-no!! ...
    (sci.electronics.basics)
  • Re: The Great Strip-X Substitute Hunt, Part 2
    ... soldering iron and leave the little solder blob on the iron and apply ... it to the end of the wire. ... ends of the fine copper wire from all the threading-through ...
    (rec.radio.amateur.homebrew)
  • Re: My soldering iron tip broke!
    ... I HATE spinach! ... I forget what model, soldering station. ... bending soldering iron tips adds to amp mojo?!? ... >> I hope my local hardware store has some tips like the one I just bent. ...
    (alt.guitar.amps)
  • Re: Anyone try any of those Bill M Blues Junior mods?
    ... tinker with my amp. ... What sort of skill level do you recommend? ... but I feel pretty comfortable with a soldering iron ... Don't underestimate the value of a QUALITY soldering iron. ...
    (alt.guitar)