Re: Ground fault


"trickyrick" <rickj@xxxxxxxxxxxx> wrote in message news:1182633893.589094.91830@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Good day
I have a little problem with my ground fault always tripping.

I have an above ground pool with a 1hp pump. I have a wire in a
conduit to the pump. The wire is 14/2 and is about 100 ft from the
panel. The pump will run for about 3 to 4 hours and then the breaker
will trip. I have metered the wire and there are no grounds or
shorts. The only thing that I can think of is maybe the size of the
wire. I did unfortunately run the pump before with out any protection
and the breaker never tripped.
Any suggestions on what might be the problem
Thanks
Rick


There are really only three reasons this breaker will trip.
1. You are overloading the breaker.
2. You have uneven hot/neutral current flow. (ground fault condition.)
3. Its defective or miswired.

Tom

.

Relevant Pages

  • Re: Ground fault
    ... I have a little problem with my ground fault always tripping. ... The wire is 14/2 and is about 100 ft from the ... The pump will run for about 3 to 4 hours and then the breaker ...
    (sci.electronics.basics)
  • Re: New Shed Wiring
    ... well was wired into the breaker box in the house. ... I know the pump at one time was set up for 120 but was switched ... Like an idiot, I let a friend run the wire, ...
    (alt.home.repair)
  • Re: New Shed Wiring
    ... digging and laying new wire in PVC out to the new shed. ... I've tried to downlod pictures of the breaker ... for the pump, which would leave you no excess capacity anyway. ... Systems that deliver 7GMP at a mere 40 PSI with 50Gallon ...
    (alt.home.repair)
  • Re: Ground fault
    ... I have a little problem with my ground fault always tripping. ... The wire is 14/2 and is about 100 ft from the ... The pump will run for about 3 to 4 hours and then the breaker ...
    (sci.electronics.basics)
  • Re: Ground fault
    ... > I have a little problem with my ground fault always tripping. ... > I have an above ground pool with a 1hp pump. ... The pump will run for about 3 to 4 hours and then the breaker ... There are really only three reasons this breaker will trip. ...
    (sci.electronics.basics)