Re: Ipod to stereo amplifer: getting volume
- From: NoSpam@xxxxxxxxxxx (Bob Masta)
- Date: Fri, 30 Nov 2007 13:11:56 GMT
On Thu, 29 Nov 2007 08:55:27 -0800, Jitt <tser827@xxxxxxxxx> wrote:
My kids had Creative mp3 players that would not produce
sufficient sound volume when connected to "aux" inputs
directly. I made an adapter cable that loaded each headphone
output with a 33 ohm resistor; this gave useable volume.
A later Samsung unit did not have the problem.
OK, I just have to ask: How does loading with a 33 ohm resistor
*increase* the volume? Normally we would expect a load to only
*decrease* volume, since it becomes the bottom leg of a voltage
divider with the output impedance of the source the top leg.
Or is there some sort of automagical sensing in the output circuit,
that increases the level when it sees a low load impedance?
Seems possible, and maybe even logical, so the same connector
can serve as headphone and line out. But I haven't encountered
it before... it this common?
Best regards,
Bob Masta
DAQARTA v3.50
Data AcQuisition And Real-Time Analysis
www.daqarta.com
Scope, Spectrum, Spectrogram, FREE Signal Generator
Science with your sound card!
.
- Follow-Ups:
- Re: Ipod to stereo amplifer: getting volume
- From: Jitt
- Re: Ipod to stereo amplifer: getting volume
- References:
- Ipod to stereo amplifer: getting volume
- From: Dominic-Luc Webb
- Re: Ipod to stereo amplifer: getting volume
- From: Jitt
- Ipod to stereo amplifer: getting volume
- Prev by Date: <<<<<<<Earn Money Online Without Investing>>>>>>>
- Next by Date: UK -scines vs electronics
- Previous by thread: Re: Ipod to stereo amplifer: getting volume
- Next by thread: Re: Ipod to stereo amplifer: getting volume
- Index(es):
Relevant Pages
|
Loading