Re: Motorcycle flasher problem.

Just for clarity, your saying that I should use the Zener 16v Diode,
1N4744. As spec'ed in the original Schematic, from + --|<-- -

Regards
.

Relevant Pages

  • Re: 12 Volt Regulated Supply
    ... and zener diode is Z3543 @www.dse.com.au ... the AC waveform minus the voltage dropped across the diode. ... because they shunt current that a load doesn't need to ground while ...
    (sci.electronics.basics)
  • Re: a604 Limp, Rebuilt, Sensors replaced, solenoid replaced still Limps!
    ... You don't need a zener diode, any old diode will do, all it is for is ... through but not the spike or surge. ... an analog might be fine here. ...
    (rec.autos.makers.chrysler)
  • Re: Getting 36v from a 12v battery
    ... Get a heavy duty 42 volt Zener diode (capable of handling the ... Get a silicon diode, 50 volt PIV ... resistor that will handle the charging current. ...
    (rec.crafts.metalworking)
  • Re: Electric circuit question
    ... switch the motor on and off indefinitely and handle the transients. ... The microswitch and diodes is a separate issue. ... direction and more than the 'main' diode in the other. ... Yes a single zener would do the job but sizing it right might be ...
    (rec.boats.cruising)
  • Re: zener diode
    ... As you might guess from the notation DZ2, ... electrical symbol for a diode. ... we know the polarity of DZ1. ... This one-to-one correspondence between the leads of the two Zener ...
    (sci.electronics.misc)
Loading