Re: need reliable 12-13 volts from 24volt wheelchair

On Feb 29, 7:36 am, dpon...@xxxxxxxxx wrote:
I have a 24 volt wheelchair that runs on 2 12 volt batteries in
series. I need output not to exceed 13 volts for my cpap machine.
There are many DC-DC converters that are labeled 24 to 12 but it seems
all of these put out 13.5 or 13.8 volts. The cpap manufacturer clearly
stated that any voltage above 13 may damage the equipment. Is there a
way to reliably shave a volt or so off of the converter output?
Perhaps by using a diode in series?  The Cpap is rated at 40watts max
or 3 amps at 13 volts. Any suggestions are welcomed, the more specific
the better.
Thanks


I have a couple of questions. Why do you have to use the wheelchair
batteries to power your cpap machine? It would make more sense to
have a 12 volt golf cart or forklift battery sitting by your bed,
dedicated to cpap use. Charge it during the day.
How do you power your cpap machine now?
You would need a good reason to use a battery bank that has an
inappropriate voltage and then down-convert it again, with the added
complexity and losses (and expense) that entails. If you power the
cpap machine directly from a suitable battery you run almost no risk
of a sudden power failure. Add a dc-dc converter to the setup and you
increase the risk.
A dc-dc converter would make sense for use away from home. But if you
stay in hotels, then using a 12 volt power supply that simply plugs
into the wall would cost a lot less and wouldn't draw down your
wheelchair batteries at night.
Just throwing out alternative ideas. But perhaps you have your own
reasons for wanting the converter, like simply taking naps in your
wheelchair, in which case plenty of engineers on this board can advise
you. I see John P has already come up with a suggestion.
.

Relevant Pages

  • Re: LEAD ACID BATTERY
    ... My circuit draw is 700mA and requires plus minus 18 volts to ... I need batteries that can atleast run for 10 to 12 ... Can anybody advice me that am I doing the right thing that will these ... Have you considered one 12V battery, and a DC-DC converter to generate ...
    (sci.electronics.design)
  • Re: Flashing
    ... Considering it has what amounts to a dc-dc converter in it (unless someone's ... molished LEDs wot run at 1.4V) that will presumably be less than 100% ... I'd guess the torch will indeed probably have an inverter to 3 volts or so in it; others which hfr one or two cells, and which I've taken to bits, have had one in them. ...
    (uk.rec.sheds)
  • Re: interesting DC-DC converter
    ... You may get as much as 100 ma or so at close to 12 volts. ... I was hoping to convert 12VDC (from a jumpstart battery I ... Would a DC-DC converter still work though for an 18VDC electric drill? ...
    (sci.electronics.design)
  • 12V-18V DC-DC converter (was: LEAD ACID BATTERY)
    ... My circuit draw is 700mA and requires plus minus 18 volts to ... I need batteries that can atleast run for 10 to 12 ... Have you considered one 12V battery, and a DC-DC converter to generate ... and I see there are CUK converters, Boost, Buck Boost, etc. ...
    (sci.electronics.design)
  • Re: need reliable 12-13 volts from 24volt wheelchair
    ... I need output not to exceed 13 volts for my cpap machine. ... There are many DC-DC converters that are labeled 24 to 12 but it seems ...
    (sci.electronics.basics)