Re: ATMEL FLIP problem

From: Rich Webb <bbew.ar@xxxxxxxxxxxxxxxxxx>
Date: Wed, 05 Mar 2008 07:57:12 -0500

On Tue, 4 Mar 2008 21:36:59 -0800 (PST), reena
<reena_chauhan83@xxxxxxxxx> wrote:

Eeyore wrote:

reena wrote:

hii
i m using ATMEL FLIP for downloading program in At89C51AC3
microcontroller.but after2-3 times i download the program it gives
time out error.even i run the program the controller does not give the
basic signals like address data line even i removed the PSEN from the
groung.. can anybuddy tell me why this is happening

I didn't even know that was ISP capable.

What's the programming interface ? I've been expereincing erratic
behaviour also with the 89S52 and Atmel's AT89ISP software.

Graham

i m using RS-232 interface .

Make sure that you're using a low enough baud rate. For AT889C51CC03
in-system programming I never go over 9600.

--
Rich Webb Norfolk, VA
.

References:
- Re: ATMEL FLIP problem
  - From: reena

Prev by Date: Re: Help with 12 volt rocket igniter
Next by Date: circuit diagram of datex ohmeda
Previous by thread: Re: ATMEL FLIP problem
Next by thread: Electronic / Electrical Calculator Tools ONLINE - GET FREE Magazines
Index(es):
- Date
- Thread

Relevant Pages

Re: ATMEL FLIP problem
... reena wrote: ... i m using ATMEL FLIP for downloading program in At89C51AC3 ... microcontroller.but after2-3 times i download the program it gives ...
(sci.electronics.basics)
Re: ATMEL FLIP problem
... i m using ATMEL FLIP for downloading program in At89C51AC3 ... microcontroller.but after2-3 times i download the program it gives ... What's the programming interface? ...
(sci.electronics.basics)
ATMEL FLIP problem
... i m using ATMEL FLIP for downloading program in At89C51AC3 ... microcontroller.but after2-3 times i download the program it gives ...
(sci.electronics.basics)