Re: Trivial question for electricians


"John Fields" <jfields@xxxxxxxxxxxxxxxxxxxxx> wrote in message
news:6bmav39vvq892oeajov1f45nbcgd097k3j@xxxxxxxxxx
On Thu, 3 Apr 2008 12:09:14 -0700 (PDT), Trickynick1001
<stargoatee@xxxxxxxxx> wrote:

Just a quick question for any electicians or the like out there:
In the summer I work construction, and I've noticed something odd.
Before the ductwork goes up in a house (that's my job), the
electricians put in temporary lightbulbs, so we can see in the
basement. They just screw the fixture to a support beam. The bulbs
are regular 60w incandescent bulbs, like you'd see in a household
fixture. I've noticed that when I hammer on the beam that the bulbs
are on, they will often get noticeably brighter after a couple hits,
usually followed by blowing out. Anyone know why this is?
My only idea is that maybe the filliament gets stretched somehow due
to the vibration, and it glows brighter because there's more
resistance created? I'm no electrician, so I don't know if that even
makes sense. Any thoughts?

---
If its resistance were to increase it would get dimmer, so I think
what's happening is that the vibration and shock is causing turns to
be shorted together, making the resistance lower, allowing more
current to flow through the filament, causing it to glow brighter and
shortening its life

JF

The filaments in ordinary light bulbs are held in place in only a couple
spots, and they can stretch and short out easily from shock and vibration
when incandescent. Ruggedized lamps have more supports, and are more
resistant to to such abuse as experienced in portable lighting (but are
less efficient because more heat is drawn from the filament). But even
better now are the more efficient fluorescent lamps (but there is still
risk of breakage, with some mercury release), so the best technology at
present is LEDs. They are remarkably rugged and also will work at wide
temperature extremes that are not tolerated by fluorescents.

Paul


.

Relevant Pages

  • Re: Trivial question for electricians
    ... electricians put in temporary lightbulbs, so we can see in the ... are regular 60w incandescent bulbs, like you'd see in a household ... and it glows brighter because there's more ... If its resistance were to increase it would get dimmer, ...
    (sci.electronics.basics)
  • Re: Trivial question for electricians
    ... electricians put in temporary lightbulbs, so we can see in the ... are regular 60w incandescent bulbs, like you'd see in a household ... are on, they will often get noticeably brighter after a couple hits, ... The resistance is actually going down as the tension on the filament draws ...
    (sci.electronics.basics)
  • Re: Anyone know anything about electric heater wire
    ... > You would want to use them in series for greatest resistance - you ... > bathroom light bar and rewiring it in series with 6 100 watt bulbs. ... ohms total. ... Based on the _cold_ resistance you would need 4x100W bulbs in parallel to ...
    (alt.coffee)
  • Re: Anyone know anything about electric heater wire
    ... >> You would want to use them in series for greatest resistance - you ... >> bathroom light bar and rewiring it in series with 6 100 watt bulbs. ... > Based on the _cold_ resistance you would need 4x100W bulbs in parallel to ... > I suspect that you might need about 20 bulbs to get those 2.7 ohms. ...
    (alt.coffee)
  • Re: Bose 201 Series II
    ... Light bulbs are surprisingly good current regulators. ... This and their slow changes in resistance makes them excellent ... It's OK to bypass the bulb if the speakers aren't worth protecting. ...
    (rec.audio.tech)