Re: Amplifier lamp replacement

Eeyore wrote:

"Dave.H" wrote:

Another question I have about this amp. There are four (output)
transistor mounted on a large heatsink at the rear of the chassis, two
of these have two core wires glued on to them.

Glued ? Do they solder to anything ?


These wires are
soldered in holes on the PC board that have the diode ( >| ) symbol.
What are the purpose of these wires?

Bizarre.

Graham

Temperature sensor,to stop over heating.
.

Relevant Pages

  • Re: Amplifier lamp replacement
    ... transistor mounted on a large heatsink at the rear of the chassis, ... Do they solder to anything? ...
    (sci.electronics.basics)
  • Re: Amplifier lamp replacement
    ... transistor mounted on a large heatsink at the rear of the chassis, ... Do they solder to anything? ...
    (sci.electronics.basics)
  • Re: Phoenix Cruiser???
    ... with a rear bedroom on a F350 chassis. ... One little slide for the sofa. ... see more and more of these, as well as the ones made on the Sprinter ...
    (rec.outdoors.rv-travel)
  • Re: Chassis Rigidity
    ... chassis itself, which absorbs bumps and helps keep the tires on the ... axle that don't rely on lifting/unloading the inside rear tire to turn. ... stagger is used on ovals to allow the solid rear axle to roll around ...
    (rec.autos.simulators)
  • Re: Squeal
    ... I'm not sure because I'm like "what the heck" (or slightly saltier ... When I get downtown, same thing -- maybe 2 miles from home). ... If chassis, is it front of bike or rear... ... If it's chassis rear, pull apart your shaft assembly inspect all moving ...
    (rec.motorcycles)