Re: Can anyone recommend good instructional videos on basic/intermediate electronics?



On Dec 16, 12:53 pm, BoldInventions <dada...@xxxxxxxxx> wrote:
On Dec 16, 3:22 am, "Mr. INTJ" <mr.i...@xxxxxxxxx> wrote:

(...)
Can anyone recommend a good set of instructional videos, lecture
series, or something like that?

My advice is to jump in and a start a modest project that you are
really interested in.  If you run into a 'gap', then search the
internet.   There are so many excellent resources out there it is hard
to imagine you have a basic question that you can't find the answer to
in a few minutes.

-Kevin

Already doing that. I've got an Arduino microcontroller board that
I've been using to control motors and servos with PWM, read rotary
encoders, etc. I just finished building a TI INA217-based preamp for
my (unbalanced) dynamic mic.

On each project, I either remember something I learned in school, or
some EE at work points out something in my circuit that's obvious once
they've mentioned it. I still have difficulty looking at a complex
circuit and breaking it down into meaningful sub-elements.

I'm trying to reach that critical mass point where you know enough,
and know where to go to look for the rest...
.



Relevant Pages

  • Re: Can anyone recommend good instructional videos on basic/intermediate electronics?
    ... Can anyone recommend a good set of instructional videos, lecture ... My advice is to jump in and a start a modest project that you are ...
    (sci.electronics.basics)
  • Re: Problem with Williams Flash
    ... Following any advice given in this message ... wire colors are also visible, so you can see how its wired. ... flashlamps are run off the 25 volt solonoid circuit. ... involved in the actual flash. ...
    (rec.games.pinball)
  • Re: Problem with Williams Flash
    ... Following any advice given in this message ... wire colors are also visible, so you can see how its wired. ... flashlamps are run off the 25 volt solonoid circuit. ... involved in the actual flash. ...
    (rec.games.pinball)
  • Re: Advice needed regarding circuit with SLA batt in tin shed
    ... >> I am designing a circuit for a small tin shed that requires backup power ... >> will be a small 12V SLA battery that will be kept on float charge (for ... >> supply/charging circuit. ... > I can't really add to the others' advice here, other than, "ventilate the ...
    (sci.electronics.design)
  • Re: Bushs Retirement Plans
    ... George Bush plans to make some "ridiculous" money on the lecture ... circuit after he leaves office. ... Just a couple of pampered kids and no need to bring them into ...
    (soc.retirement)