Re: decoupling caps placement



"David L. Jones" wrote:

"tempus fugit" wrote:

I've got a circuit that uses 3 4049 inverters. On this IC, the V+ is on pin
8 and the ground is on pin 1. I know that the decoupling caps need to be as
close to the IC as possible, but how can I connect 1 end of the cap to V+
and the other to ground when the pins are so far away?

There are many ways to do this depending on how your board and circuit
are layed out.

But it's 4000 series ! It's almost ANALOG !

In fact some analog circuits do use 4000 series.

Graham

.

Relevant Pages

  • Re: WTB: Power supply for Heathkit "home" version of Fireball (Bally?)
    ... pin work in this Fireball home version pin. ... I also had to build a pass through circuit ... that carried fuses and returned back to the board for the 22v (coils ... board and then go directly off board again through fuses. ...
    (rec.games.pinball)
  • Re: decoupling caps placement
    ... I've got a circuit that uses 3 4049 inverters. ... pin 8 and the ground is on pin 1. ... sufficient to connect 1 end of the cap to V+ and the other to a nearby ... If building on veroboard or solderless breadboard, make sure you have reliable power and ground rails. ...
    (sci.electronics.basics)
  • Re: SyncMaster 151s LCD monitor turns itself completely off after 20 minutes
    ... This IC has a built-in thermal shutdown latching circuit for when it is ... UC3842 PWM IC, there are a couple ... V or pull pin 1 below 1 V, ...
    (sci.electronics.repair)
  • Re: Help Identifying three ICs
    ... Chris wrote: ... Is there a machine which you can plug in a 16 pin IC and it will tell ... I have a circuit board with three 74lS???? ... I'd look around for an old EPROM programmer, or take a look at eBay. ...
    (sci.electronics.basics)
  • Re: RCA projection TV Problem
    ... It is possible your convergence amp circuit has failed, ... Also, if you try to use adjustments in the service menu, or manual ... pin 1 should be -45, ...
    (sci.electronics.repair)
Loading