Simple design - will it work
- From: "Jim" <jim@xxxxxxx>
- Date: Wed, 8 Jul 2009 13:03:46 +0100
Guys
I need to wire up a remote switch for a milling machine in my garage.
Rather than go into a lot of detail all I need to achieve is continuity
betwenn A & B on the linked diagram but I can only use a momentary switch
(SW1)
http://rapidshare.com/files/253373634/2443_001.pdf
Can someone confirm if the planned circuit will work ie when SW1 is
momentarilly closed then continuity will provided aacross A&B until the 12V
power is switched off.
Also on a different topic, I need to connect a 10k pot to my inverter to
vary the power output. Circuit diagram shows 3 connections,
1) +10V (Power terminal of Pot)
2) Analog frequency signal input terminal
3) 0VAnalog common point
Any idea how I identify which pin is which on my pot
Cheers
Jim
.
- Follow-Ups:
- Re: Simple design - will it work
- From: baron
- Re: Simple design - will it work
- From: petrus bitbyter
- Re: Simple design - will it work
- Prev by Date: 〓〓Wholesale Versace,Gucci,DG,LV,DB,Coach,C-hanel Wallets WWW.fjrjtrade.COM fashion&the best quality with low price (paypal payment)
- Next by Date: Re: Driving LEDs with a battery pack
- Previous by thread: 〓〓Wholesale Versace,Gucci,DG,LV,DB,Coach,C-hanel Wallets WWW.fjrjtrade.COM fashion&the best quality with low price (paypal payment)
- Next by thread: Re: Simple design - will it work
- Index(es):
Relevant Pages
|
