Eagle auto routing newbie question

myoldmitsu_at_yahoo.com.au
Date: 11/20/04 

Date: 19 Nov 2004 20:51:02 -0800

Hi all,

Here it goes.

I use Eagle layout editor 4.

I have created a schematic and I switch the board where I place the
components. I start the autorouter, everything works fine but let's say
that I realise that the design would benefit from moving one component
to another location. Moving the component is no drama but my problem is
that I can't figure out how to start the autorouter with the new
layout.

Advice how to do this is very much appreciated.