Re: Power Mosfet Biasing

From: Ali Electronics (ali_at_vuetec.com)
Date: 01/01/05 

Date: 1 Jan 2005 12:52:43 -0800

yes I used that configuration.

so what should I do?

I just want to switch the 100volt on and off by changing the gate
voltage.

any idea?

Relevant Pages

  • Re: P-channel Mosfet switch?
    ... If i turn on the transistor and sink current through the gate resistor ... it raises the gate voltage up to Vce minus Vsat.Shutting the fet off. ... Roff spice stiil shows the battery voltage when the switch opens. ...
    (sci.electronics.basics)
  • Re: using mosfets as rectifiers?
    ... >>drive the gate with a lower voltage. ... can use a partially conducting mosfet. ... I am however going to use a mosfet to switch my load, ...
    (sci.electronics.repair)
  • Re: using mosfets as rectifiers?
    ... >>drive the gate with a lower voltage. ... can use a partially conducting mosfet. ... I am however going to use a mosfet to switch my load, ...
    (sci.electronics.design)
  • Re: High side, high voltage (~60V) N-FET driver chips
    ... battery packs and switch them on and off so as to protect ... To get the N-FET gate voltage high enough (~65-75V methinks, ... How else would I drive the gate high enough? ...
    (sci.electronics.design)
  • Re: MOSFETs and PWM
    ... would have to pull the gate higer than 12V. ... The curves of drain current versus drain voltage, ... that went above +10 gate voltage, even to switch 600 volts, and there ...
    (sci.electronics.basics)