Re: Controlled impedance (stripline etc.) boards

optoeng_at_pioneernet.net
Date: 01/06/05 

Date: 6 Jan 2005 07:24:31 -0800

Look for an article by Dr. Eric Bogatin in latest Printed Circuit
Design. Don't know if it's on the web yet or not.
Paul Mathews

Spehro Pefhany wrote:
> Hi,
>
> Does anyone have references for crosstalk and impedance of stripline
> and microstrip designs that have analog signal traces relatively
close
> to ground strips (on the same layer as the signal traces)?
>
> The spacing I get for the desired max level of crosstalk without this
> is uncomfortably large.
>
> Thanks in advance.
>
>
> Best regards,
> Spehro Pefhany
> --
> "it's the network..." "The Journey is the
reward"
> speff@interlog.com Info for manufacturers:
http://www.trexon.com
> Embedded software/hardware/analog Info for designers:
http://www.speff.com

Relevant Pages

  • Re: ac voltage divder
    ... I need to design a voltage divider, that is going to drop 15vac. ... Spehro Pefhany ... Same as a transformer, but gives no isolaton. ... isolation would a 120:15 tranformer give in when properly connected in ...
    (sci.electronics.design)
  • Re: The Electric Car
    ... On Aug 1, 6:27 am, Spehro Pefhany ... of fuel per cycle and says that it wouldn't. ... in a practical production car. ... do that is an example of bad design. ...
    (sci.electronics.design)
  • Re: Analog use of CMOS logic chips
    ... Spehro Pefhany wrote: ... No, no, you can get in trouble for archiving the dirty pictures. ... Wescott Design Services ...
    (sci.electronics.design)
  • Re: Need simplest circuit to convert momentary switches to latching "switches"
    ... Spehro Pefhany ... here's an old P&B design available in surplus: ... Digikey has some similar ones in stock for $47.64 ...
    (sci.electronics.design)