Thermal Relief in Protel

From: "Brendon" <someone@xxxxxxxxxxxxx>
Date: Mon, 22 Aug 2005 15:12:52 +1200

Hi All,

I want to have a pad on the board with no thermal relief, connected to a
plane. How do I do this in Protel 99 SE? Is there an option somewhere?

Thanks,
Brendon

.

Follow-Ups:
- Re: Thermal Relief in Protel
  - From: cgoldenbus
- Re: Thermal Relief in Protel
  - From: Brad Velander

Prev by Date: Re: Protel x Ares Lite
Next by Date: Re: Thermal Relief in Protel
Previous by thread: Re: Protel x Ares Lite
Next by thread: Re: Thermal Relief in Protel
Index(es):
- Date
- Thread

Relevant Pages

Re: Thermal Relief in Protel
... Brendon, ... you'll have to create a new design rule under plane connects. ... Select the net and change the thermal relief type to direct connect. ...
(sci.electronics.cad)
Re: OrCAD Layout - good ground
... plane, set the button that says to use the copper pour for connectivity, and then set no fill zones around areas where you don't want the copper to leak into. ... The idea is try to make the flood fill approximate to a continuous ground plane, rather than a set of disconnected leaves. ... thermal relief pads, otherwise the pads will wick and draw up solder and you will have ...
(sci.electronics.cad)