Re: EDWin2000 Copper pour areas

Hello,

If I have well understood :
- you have routed your card;
- you add a copper pour area, connecting to a specific net;
- and your area doesn't connect with existing traces within this
net...

I use EdWinXP V1.40 for my projects and here is how I do starting from the
same point as above :
- I go in Layout editor click on "Route", then on "Autoconnect
traces", then on "Autoconnect Net";
- and after that, you have just to click on a trace or pad within
your net, answer "YES" to the question "route net?<NETNAME>", then answer
"NO" to the question "keep already routed connections unchanged?<NETNAME>"

That's all, traces and pads within the same net are connected to the copper
pour, traces outside copper pour area ar also connected to it....

I hope that will solve your problem.

Just a notice about EdWinXP. Lot of people say it's a awful software.....
But I don't think so : I use it now for 2 years, making general electronic
projects, and I think that with a little experience, reading the help file
or viewing the .avi "How to do..?" mentioned in the help file, this software
is pretty good, I can do all what I want. I never saw the bugs (????)

Best regards,

Pat


<blooddawn@xxxxxxxxx> a écrit dans le message de news:
1128945069.099407.291730@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> Hi, is there anyone who can tell me how to connect pcb traces and
> copper pour areas (in the same net)?
>
> When I place a copper pour area over traces within the same net I
> expect this area to connect with them, is this not standard practice?
> If it is, please tell me how to do it.
>
> Best regards,
> Andreas Eriksson
>


.