Re: Good, relatively low cost PCB layout SW?

Leon ...

Do you have a legit copy of an obsolete Windows version of Easy-PC you'd be
willing to sell? I used Easy-PC DOS about fifteen years ago and it was a
bitch kitty when trying to make new parts. It was also DOS-Version specific
so when Microlimp came out with a new version of MSDOS, Easy-PC choked on
it. I couldn't mess around with what was then hobby-level software with
buggy parts.

I've heard you all rave over the newer versions, but I'm not all that
thrilled with the demo I downloaded a couple of years ago. Perhaps the
cripple code made it less than I expected.

I've also got about ten years of CircuitMaker/TraxMaker PCB files that I
will have to port over to whatever new program I decide upon. CM can export
in Protel, Tango, Orcad, and a few more, and TM can export in Gerber or
ProtelText format. Do you happen to know if EZPC can accept any of these
formats?

Thanks,

Jim




"Leon" <leon_heller@xxxxxxxxxxx> wrote in message
news:1131804480.685625.48500@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> EasyPC:
>
> http://www.numberone.com
>
> I used it for years.
>
> Leon
>


.