Re: Has anyone produced a board using Kicad?

I was wondering if anyone here has ever designed and produced a working PCB
with Kicad, the free open-source CAE package. I've looked around but haven't
found anything.

I haven't built any board with it, but I did work with it enough to
be sure I could use it if I needed to.

I think the key idea is that the auto-router is next to useless.
Are you prepared to hand route your whole board?
--
The suespammers.org mail server is located in California. So are all my
other mailboxes. Please do not send unsolicited bulk e-mail or unsolicited
commercial e-mail to my suespammers.org address or any of my other addresses.
These are my opinions, not necessarily my employer's. I hate spam.

.