Re: How To vary "vsin" amplitude in a graph?

On 14 Sep 2006 21:31:03 -0700, "june" <gahaja2000@xxxxxxxxx> wrote:

Hi! I'm using ORCAD capture CIS 9.2 LITE and I'm simuating a circuit.

I have to vary only the amplitude of <vsin> and see the output
variation in the graph.
How can I do it?

amplitude should vary from 0~2V, with 0.2v increment.

I guess there would be an answer similar to amplitude variation of
<vdc> by DC sweep.

In the amplitude setup for vsin, insert {VP} instead of a number.

Declare the parameter, .PARAM VP = 1

In parametric Analysis, Global Parameter, VP, STEP, LINEAR, 0, 2V,
0.2V

Run a Transient Analysis for at least 10 cycles of vsin

To get a "graph", in Probe choose Trace, Performance Analysis and use
the "Wizard" to pick the measurement you want to graph, until you get
the hang of it, then it's faster to just type in what you want.

...Jim Thompson
--
| James E.Thompson, P.E. | mens |
| Analog Innovations, Inc. | et |
| Analog/Mixed-Signal ASIC's and Discrete Systems | manus |
| Phoenix, Arizona Voice:(480)460-2350 | |
| E-mail Address at Website Fax:(480)460-2142 | Brass Rat |
| http://www.analog-innovations.com | 1962 |

I love to cook with wine. Sometimes I even put it in the food.
.

Relevant Pages

  • Re: How To vary "vsin" amplitude in a graph?
    ... Thank you Jim Thompson! ... I guess there would be an answer similar to amplitude variation of ... In the amplitude setup for vsin, insert instead of a number. ... To get a "graph", in Probe choose Trace, Performance Analysis and use ...
    (sci.electronics.cad)
  • Re: Why is Microsoft Word Complaining About This Sentence?
    ... The variation of yy with xx is shown in Figure 7. ... Figure 7 displays a graph of yy against xx. ... The earth is kept in orbit by the gravitational attraction ... The gravitational attraction of the sun keeps the earth in ...
    (alt.usage.english)
  • Re: annual variation
    ... (Still laughing) ... Try "Daily mean relative humidity, ... If you wish to emphasise or draw attention to the variation you could ... the graph will speak for itself. ...
    (alt.usage.english)
  • Re: Adding som kind of cursor in waveform chart
    ... Here is a variation on the example Joe mentioned. ... Look at how the graph was modified to look like a chart. ... Message Edited by tst on 07-27-2005 05:08 PM ...
    (comp.lang.labview)
  • How To vary "vsin" amplitude in a graph?
    ... I'm using ORCAD capture CIS 9.2 LITE and I'm simuating a circuit. ... I have to vary only the amplitude of <vsin> and see the output ... variation in the graph. ...
    (sci.electronics.cad)