Re: PDA/handheld that can do CAD?


"Joerg" <notthisjoergsch@xxxxxxxxxxxxxxxxxxxxx> wrote in message
news:ERBhh.9399$Ga1.6325@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Hello,

Let me repeat a question I asked on the Cadsoft group since there are also
users of other CAD systems here: Is there a PDA or other handheld that can
be used for schematic entry and editing, plus maybe writing the module
spec to go with it?

In other words something that has enough RAM and Flash to run Eagle or
similar programs but where the processor does not have to be powerful. Of
course I don't plan to do layouts that way (don't do layouts myself
anyway).

--
Regards, Joerg

http://www.analogconsultants.com

Eagle does not seem to use a lot of memory, less than the 20mb.
The real hurdle is running it on Win CE. If it uses any functions that are
stripped out to make it CE then your out of luck.
Hmmm, there are simulators.....

Cheers


.

Relevant Pages

  • Re: PDA/handheld that can do CAD?
    ... Let me repeat a question I asked on the Cadsoft group since there are also users of other CAD systems here: Is there a PDA or other handheld that can be used for schematic entry and editing, plus maybe writing the module spec to go with it? ... In other words something that has enough RAM and Flash to run Eagle or similar programs but where the processor does not have to be powerful. ... Of course I don't plan to do layouts that way. ...
    (sci.electronics.cad)
  • Re: PDA/handheld that can do CAD?
    ... also users of other CAD systems here: Is there a PDA or other handheld ... course I don't plan to do layouts that way (don't do layouts myself ... nice if that PDA could run regular Windows, just without the glitz and on ... The other problem is they usually run a risc processor so you'd have to ...
    (sci.electronics.cad)
  • PDA/handheld that can do CAD?
    ... Let me repeat a question I asked on the Cadsoft group since there are also users of other CAD systems here: Is there a PDA or other handheld that can be used for schematic entry and editing, plus maybe writing the module spec to go with it? ... Of course I don't plan to do layouts that way. ...
    (sci.electronics.cad)
  • Re: Cadsoft GmbH an Farnell verkauft
    ... da ich mit Eagle auch bis jetzt gut klar ... dann würde sich das eventuell lohnen, aber dann wäre es wohl sowieso ... Ich kann es hauptsaechlich fuer USA sagen, aber bis auf sehr wenige Kunden macht keiner von denen die Layouts im Hause. ...
    (de.sci.electronics)
  • Re: Choosing a ferrite bead
    ... Michael Noone wrote: ... 'serious' board - all my other layouts have been much smaller boards that had a small fraction of the components that this board has. ... Are you familiar with Cadsoft's Eagle? ...
    (sci.electronics.design)