Re: frequency response

All these .AC simulations will require to setup the appropriated
DC condition for the LM317. This means you would apply a DC
voltage of e.g. 32V at the input with an additional AC definition.
It would be also necessary to add the correct load device,
e,g, a resistor load or a current source load.

I'm not sure I quite understand this. I am suppose to change "v1 4 5
dc 0 sin(0 34 60)" to "v1 4 5 dc 34 sin(0 34 60)" thereby giving it a
dc defintion?

.

Relevant Pages

  • Re: Will Radio Engineering be QMs worst nightmare?
    ... See what kind of voltage gets produced by 150 watts ... I am thinking of an amplifier that is turned on with no load. ... > don't increase because the load resistance changes. ... What kind of amp. ...
    (sci.physics)
  • Re: Flyback transformer design confusion!!
    ... When applying a constant DC voltage across a resistive ... load, just *how* can I increase the power into that load, other than by ... Iout is to change the resistor. ...
    (sci.electronics.design)
  • Re: HELP! Onan Emerald III No AC
    ... I replaced the fuse and let it sit for a minute. ... motor purrs along just fine and does not blow the fuse. ... I applied the load and the surging was ... 'transformer regulated' set - no electronic voltage regulator. ...
    (rec.outdoors.rv-travel)
  • Re: NFB101 part 3
    ... the FB voltage is from a simple resistance divider, ... be more familiar to tube heads than op-amp like triangles. ... as the gain reduction. ... The load affects the output tube open loop gain, ...
    (rec.audio.tubes)
  • Re: HELP! Onan Emerald III No AC
    ... I have tried several times today to start the gen set back up. ... motor purrs along just fine and does not blow the fuse. ... whether it wants to produce the proper voltage or not. ... When I shut off the load the gen sounded ...
    (rec.outdoors.rv-travel)