Very Basic Question on Protel DXP 7.2

I have been using ORCAD, now forced to switch to an older version of Altium.

(Design Explorer 7.2.92) circa 2002.

With ORCAD a Netlist is generated in Schematic Capture which is then used
by Layout to generate the PCB connections.

I have been unable to figure out how to do the equivalent in DXP. Several
Netlist
options are available in DXP schematic build, but I've been unable to see how
the
PCB layout portion loads these. (Or which Netlist option is the proper one to
use
for that matter.)

Using this older rev of DXP, how do I properly transfer a schematic into a
PCB
layout?


Thanks much in advance.
Terry

.